![]() 'Clone failed - Read failed - 13 - Broken pipe' "While I was trying to clone my OS from HDD to a new Samsung 840 SSD using Macrium Reflect, I keep getting an error that says And in different situations, it shows different error messages. If you are unfortunately caught by this issue during disk cloning, please don't worry! It is not a big issue and there are some possible ways to help you out. Solutions Run CHKDSK to check & repair source disk errors that might cause Macrium Reflect clone failed issueġ.Click 'Start' > 'All Programs' > 'Accessories' then click 'Command Prompt'.Ģ. ![]() Type 'chkdsk C: /r /f', with "C" replaced with the letter of your source drive if different, and press Enter. The command will start CHKDSK to perform a full scan on the source disk and repair all the errors, bad sectors or corruption it finds. Just bought a 256gb SSD to replace my 128GB SSD. When it completed, reboot your PC and try the clone again.Īs chkdsk does not always capture and fix all the disk problems, it is likely that Macrium Reflect still cannot complete the disk cloning process. Want to clone the old to the new and make use of its extra space. Try an alternative software when Macrium Reflect clone failed after CHKDSK Watched a tutorial on cloning using Macrium, fairly straightforward (see attached). If it happens, we recommend you to try EaseUS backup software as an alternative solution to manage the disk clone job.
0 Comments
Leave a Reply. |